Loose Speedo Cable?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 4, 2008
Threads
55
Messages
210
Location
Mission BC
So I am in the process of doing my first Transmission Fluid Exchange and I noticed something amiss. Should my Speedo cable be a bit loose despite the 12mm nut being tight? There is a bit of wiggle where the speedo assembly seats. The tab that bridges the bolt to the assemly is in the proper slot. The seat inside the housing is clean. This just doesn't seem right. Also I could assume this is the origin of the fresh oil in the sourrounding area as there are no other oil leaks. With 60K miles and having been a pavement princess from Tokyo ( my plastic skidplates are unblemished :rolleyes: ) I don't think anything's been serviced - yet :meh:
 
Makes sense, can't use a generic O-ring? Not that I'm unnecessarily cheap, just I have a kit of them.
 
Ditto - just replace the O ring. Call Cdan, but speak with one of the other parts guys as he's on vacation and mention the Mud forum.

DougM
 
Back
Top Bottom