I've been having some issues with my braking. I've gone through two new rotors and have gone through my front hub probably about six times. Each time I would disassemble, clean, lubricate, reassemble and re-torque the hub assembly. And each time I would get the same results -- My brakes have this grab/catch feeling. Assuming my rotors didn't come warped, even with new rotors I've had the same results.
I've noticed one thing though, the lock nut washer is loose. It's loosened up over the years and at the last disassembly (today) can almost spin freely. The diameter of the washer itself seems too large, thus the tab doesn't fully seat in the groove on the spindle.
So the grabbing/catching feeling that I'm getting could be the lock nut spinning around the spindle and grabbing the groove. I ordered two new washers at a local Toyota dealer, and I'll see how it works out. I'll probably have to go in and get new rotors, bearings, rebuild my calipers.....



I've noticed one thing though, the lock nut washer is loose. It's loosened up over the years and at the last disassembly (today) can almost spin freely. The diameter of the washer itself seems too large, thus the tab doesn't fully seat in the groove on the spindle.
So the grabbing/catching feeling that I'm getting could be the lock nut spinning around the spindle and grabbing the groove. I ordered two new washers at a local Toyota dealer, and I'll see how it works out. I'll probably have to go in and get new rotors, bearings, rebuild my calipers.....


