Late Model Half Doors (project)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 23, 2004
Threads
44
Messages
886
Location
Chattanooga, TN
Well, this is how I spent the weekend, thought I'd post some pics of the progress and solicit some advise for capping them. I've read all the posts, but they deal with early (thin) doors only. I'm probably gonna follow Jack Rice's lead and try to recreate the factory looking edge, most likely by having a local sheet metal shop fab it up and i'll weld it in.

these were my original doors and I picked up a much nicer set from Rascal when I bought his SOA in a Box last year to keep as a full set. Just cut the worst of the two pairs.


This was a bit time consuming, but I was being careful and trying to think things through before cutting (I've not always been good at that :grinpimp: )


These are the things I wanted out of my half doors:
--retain the side mirrors as I HATE the windshield mounted ones
--comfortable armrest and stock look...sorta if it makes sense
--retain the stock hardware and door striker...just looks better and makes it simpler to switch the doors out.

​
Cut the Driver's door while it was on the truck and then brought them home to finish them up.


Any questions feel free to ask! On to the pics
Half door mounted 640.webp
Half Door Ground.webp
Half Door hardware jpg.webp
 
A few more...

BTW, does anyone have a source for clip nuts (the captive nuts with the panel/sheet clip)...thinking these would be a good way to attach the nuts to the inner door hardware...easier is to just weld nuts to the back once its mounted and before its capped, but I lose the ability to adjust the handle east/west.

thoughts?
Half Door inner hardware jpg.webp
Half Door outer hardware jpg.webp
FJ40 rear w door.webp
 
Just take your time welding those up!!!!!!!!!!! I pushed it a bit and both my doors are warped. I haven't spent too much time trying to fix them, but just a word of advice.

Looking good so far.

Brian
 
Looks GREAT! Can't wait to see it on the trail!
 
Looks great so far. I remember reading in another thread about someone using exhaust pipe (1.5"?) to cap the door for a rounded shape. IIRC they didn't split the pipe down the center but just set hte whole pipe into the opening and welded in place. I am planning on making a set in the near future and thought it sounded like an easy method for a clean look. HTH. :beer: :beer:

Clint
 
That works for the older thin doors and looks great, but those doors are pretty simple (maybe I should have used them!) whereas the newer doors are much wider (~2.5--3+ in) and the width varies b/c they are molded for support. This is whats complicating the capping (at least in my mind)

If I just slap on some flat stock, I just don't think it'd look right or be as comfortable as I'd like...That's why I'm trying to recreate the profile of the original window opening...I just wasn't smart enough to try an section the door. I be adding pics as progress is made.

Still need a source for those captive nuts...something like "D" below, everything I've found is wholesale boxes
jtypenrcat.gif
 
Back
Top Bottom