Okay I'm lazy, I didn't search. But hey if the same question came up again it must be relevant to todays IH8mud user right?
Here it is, I'm doing a toy truck knuckle conversion on my FJ40. I consulted my FJ40 Haynes manule (No I don't have a FSM) for torque and preload specs.
Then I'm thinking, 10MM vs 12MM knuckle studs, after market steering arm, 2 1/8" spindle nut, hrmmmm those FJ40 specs may be way out of line.
Any body know what I should be torqueing and preloading to ? I know there is a torque wrench method of setting pre-load, seems like that would eliminate differences due to steering arm length.
The first relevant link to an IH8mud thread gets a Woody Award or "A Woody" for short.
Here it is, I'm doing a toy truck knuckle conversion on my FJ40. I consulted my FJ40 Haynes manule (No I don't have a FSM) for torque and preload specs.
Then I'm thinking, 10MM vs 12MM knuckle studs, after market steering arm, 2 1/8" spindle nut, hrmmmm those FJ40 specs may be way out of line.
Any body know what I should be torqueing and preloading to ? I know there is a torque wrench method of setting pre-load, seems like that would eliminate differences due to steering arm length.
The first relevant link to an IH8mud thread gets a Woody Award or "A Woody" for short.