Knuckle Gaskets - FIPG?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 27, 2003
Threads
490
Messages
9,929
Location
North Cadillac
Just curious what everyone's thought on this is.

I've had to pull my front end apart, again, because i popped my front diff on a rock last year in UT which caused a slow front diff leak.

on my rear axle, i rebuilt it a couple of years ago and used FIPG for the rear pinion seal. I plan on doing the same for the front this time. But my question is what about the other paper gaskets in the knuckle rebuild kit? Has anyone used FIPG for those instead? I'm thinking about FIPG the knuckle with the exception obviously of the wipers.
 
im assuming that your asking about the drive flange gasket and yes you can use fipg, the red stuff is what should be used. i tore my gasket when installing the rear axles and just gave it a dab of red and no leaks so far
 
I use FIPG only for the t case and 3rd member seals. My 3rd member paper seal tore after a few wheeling trips when a couple of the nuts loosened up. Had I used FIPG I would have had been able to retighten the nuts and went on my way, it's more forgiving. Also, had I Checked torque the paper seal probably wouldn't have failed either.

That being said, I wouldn't use FIPG for any of the other seals mainly because they are not expected to see continuous oil flow and are keeping things out rather than in (a small bit of intrusion that occurs when a paper seal fails is minor in my opinion). Also, on my 4runner (similar design), the P.O. used FIPG and it was horrible to disassemble and clean everything.

Just my two cents.
 
Yea, i've had the third member paper gasket fail on me 3 times. But the rear third member flange has lasted for 5 years which is FIPG.

So now i'm staring at my knuckle assembly that is broken down and i've got the paper gaskets on the way, but i'm looking at it and thought why not use FIPG?
 
Back
Top Bottom