Keys lost

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 27, 2004
Threads
119
Messages
821
Location
Los Angeles
I've got a 97 stored, and I just discovered I've apparently lost the keys.

The truck has no battery, and I've also lost the key fob transmitters.

So, can I slim-jim the truck open on the passenger side (I can't access the drivers side the way the truck is parked right now)?
I have complete access to the right (pass) side of the truck, and also the rear hatch. It's parked tight against a wall on the left, so I can't get to the doors on the drivers side.

Also, on some cars, there is a key code stamped into one of the key cylinders in the door.

Does anyone know if that's the case with the passenger side lock cylinder? I could have a locksmith make a key from the cylinder, even if there's no code.

thanks

Dana
 
I dont know about using a slim jim on your door, better do it on a full stomach. Not to mention they are a tad greasy, so have windex handy.
slim_jim.webp
 
Dana, PM sent. First of your post should NOT be answered on a forum.

Why not? Any car can be broken into, that's what thieves do. Absolutely a functional key can be made using the door cylinder. A call to an automotive locksmith can get a working key for your vehicle in situ, most likely for less hassle time than dismantling the door to pull the cylinder.

HTH and my .02

Scott J, CRL
 
Anybody know what the dealor charges for a LX code cut key?
 
Anybody know what the dealor charges for a LX code cut key?

Seems there is some confusion here. There is a difference between a "Code Cut key" and a "VIN>Code Cut Key". A code cut key will be from either the code tags that came with the original keys, or from a lock identifier code. These codes are accessable and available to any automotive locksmith to cut the original specification key. The Vin Code Cut key, is thru the dealer/manufacturer, and is basically a reverse lookup of the key code by VIN.

The dealer charge for a VIN reverse lookup for a non-transponder code cut key is expensive compared to either a locksmith code cut, or even a locksmith service call. IME with disc tumbler keys, many times a code cut key may or may not work, depending on the conditions of the tumbler discs.

HTH

Scott J
 
I've had several customers who have wanted/needed extra keys made. Using the VIN has always produced a functioning key. Usually the cost for a rubber-headed, non-transponder key is less than $10
 
I have always had great results from Toyota VIN/code cut keys and reasonably priced. The LX key is always more $$$, very few private locksmiths have the mill needed to cut them.
 
Back
Top Bottom