ISC harness pin question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 16, 2007
Threads
17
Messages
100
Location
Jupiter, FL
My idle speed is at a constant 900-1100 RPM, regardless of engine temp. I did notice that the connector has space for 6 pins, but only 4 are present. It looks as if the center 2 could have been removed. Does anyone know off hand if there are 4 or 6 pins in a 'complete' connector?

ISC has been removed and cleaned, but this had no effect on idle speed.

Thanks for any input.

Jason
 
You said you cleaned the sensor, but did you clean the housing that it sets in? have you also looked at or cleaned the throttle body? If either are dirty they can cause some interesting symptoms.
 
Yeah, all parts of the ISC, mating surfaces, throttle body, etc are spotless now. I didn't disassemble the ISC or TB, but neither was terribly gummed up. Just a tiny bit of carbon on the plunger and its seat and a very thin layer of crap on the butterflies. The TB fully closes at idle, new throttle cable has a little slack, so I'm thinking ISC.

Could someone let me know if there are 4 or 6 pins on the ISC connector? I can find no pics in my search, and it's not covered in the crappy manual I have.

Thanks.
 
Back
Top Bottom