We just finished tearing down the F from the FJ45LV. There are NO boring marks in the cylinders at all which makes me think that they have all been honed away or the cylinders are ovaled (no marks on the pistons that I've been able to see to indicate oversize). The oil clearance on the bearings is on average 0.1mm on the connecting rods and 0.15mm on the crank (0.1mm being the maximum). The connecting rods already have 0.5mm undersized bearings and the crank has 0.75mm undersize bearings. There is at least one main journal on the crank that is slightly scored.
I'd be rebuilding more with the intent of either selling the engine or just using it as a sample for the shop as I'd rather have a diesel in the FJ45LV.
Labor for boring and that is cheaper here than stateside but I'm not interested in throwing good money after bad.
What would you do?
1. Rebuild to spec and try to sell it.
2. Rebuild with the same pistons but new bearings and sell.
3. Just throw it back together (after cleaning of course).
4. Ditch it now (but the kids won't learn anything that way).
I'd be rebuilding more with the intent of either selling the engine or just using it as a sample for the shop as I'd rather have a diesel in the FJ45LV.
Labor for boring and that is cheaper here than stateside but I'm not interested in throwing good money after bad.
What would you do?
1. Rebuild to spec and try to sell it.
2. Rebuild with the same pistons but new bearings and sell.
3. Just throw it back together (after cleaning of course).
4. Ditch it now (but the kids won't learn anything that way).
