Intermitant electrical blown fusabllink

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 5, 2018
Threads
1
Messages
8
Location
Sacramento
Any ideas. I have a question. My fzj80 keeps blowing a fusable link when I come to a stop and accelerate again. But only after about a mile or so and several turns.
I have replaced several electrical components. It would run in the driveway indefinitely. But when I would drive it on the road.it would blow. I replaced the fixable link after buying three link sets. It still blows when driving. I have checked all of connections and grounds. ?????
 
Sounds like revving the motor (coming away from those stop signs) -may be a precursor to when you pop a link.

Seeing the volt guage wander any? (really would help to have an amp gauge to get more accurate)

Voltage regulator on the alternator?
-That's where I'd start.
 
Figure out what link it is, and what's on that circuit.

My blind guess is the wiring harness where it goes through the firewall. Insulation has been abraded and when bounced it makes contact with the body. Purely a guess, though.
 
Yeah, I thought about that but It is the reusable link that doesn't go to the alternator. From the battery through the fusable link through the ignition switch and directly to the ECM. From there it goes to the ignition system.coil, igniter, distributer.. I'm kinda tho king am. But could be a ground short? Unknown.
 
Yeah, I thought about that but It is the reusable link that doesn't go to the alternator.

I don't understand. AM2 goes through the firewall to the ignition switch, then to the igniter and ECU. I'm looking at the '94 wiring diagram, but I doubt this portion of it changed through '97.

I also don't know what you mean by reusable link.
 
Stupid phone auto correct. Fusabllink. There is nothing else on that circuit. I have reved it while jiggling the wireharnesses and it didn't blow. You don't think the camputer malfunction has enough current to blow a link? It would have to be a ground short or overload. But all of the fuses for each system are in tact. Driving me crazy....
 
There is nothing else on that circuit.

There's a bunch of stuff on AM2:

20180205225612-164ec213.png
 
Thanks for the diagram. I replaced the igniter and the coil. I have checked all of the power and continuity for those lines. The d istributer is the next possibility but in my driveway revved and idled for 20 30 minutes, no issue. I even thought maybe the and was a problem somehow. So I disabled it and tested it and broke down on the road around my house.
 
I am sorry if this sounds "to easy" but is sounds like this occurs whenever motion is present. Is your battery bolted down? are you simply stretching or tearing the shortest link?
 
Everything is secured. I was thinking maybe ABS or traction control in the ECM sends a over load back through. I'm not sure that is possible. I disconnected the and fuse and drove it and broke down. So. I have checked all of the relays under the hood and under the dash. There is a transmission module I have texted the power to. But I don't think that would cause a fusabe link to blow.
 
Fusing when throttled, a common failure is the main engine harness where it passes the EGR pipe. There was a clip that held the harness away from the pipe, likely disintegrated, allowing the harness to short on the hot pipe. Tie the harness back to the clip mount with zip-ties and see if it still does it.
harness_zip_1-jpg.1480405
 
Hey there, I inspected and it sure enough is leaning up against the E G R pipe. I can't dig into it today. But I am thankful for the suggestion. I appreciate it. I will update when complete.
 
Back
Top Bottom