Ih8rust

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 7, 2004
Threads
23
Messages
1,019
Location
Eastern PA.
So I buy a 76 top for my 74 FJ40 on Ebay, Looks good in the pictures, looks good when I get it. I store it away till the I'm ready to do the top. I strip the sides and there's a 1/16 of bondo on the whole thing. Holes open up all over the place. Now I was thinking strip, paint and install... maybe a month till I'm driving it. Now I'm Mr. Miggy McGrinder for the next month :doh:



Kevin
 
what did you strip the sides with? Grinder/sander or paint stripper? Just curious. I'm about to start the same project. I'll probably be looking for some new sides once I get into these old ones.
 
RedGreen said:
what did you strip the sides with? Grinder/sander or paint stripper? Just curious. I'm about to start the same project. I'll probably be looking for some new sides once I get into these old ones.

Wire wheel on a angle grinder. Works great, stripped the whole 40 that way. Wire wheel then sand, die grinder with a wire cup for the tight areas. Only went through 6 wheels and 2 angle grinders doing the 40 :doh:

Since I was doing it a little at a time it made more sence than draging each peice down to the sand blaster as I was ready.

I'm going to weld this one up. Started last night on the window frame.


Kevin
 
where do you find the wire wheels? I've only seen the ones at HD that fit the bench grinder. They never seem to have wheels that will hold together at 12,000 rpm. Looks great though. Makes me want to get out to the garage and start working on it.

Do you spray it with primer as soon as you finish each piece? Or do you just use some Rustoleum until it's ready for primer and paint?

Thanks.
 
I have a Makita angle grinder and I get Makita wire wheels made for it. The supplier I use stocks them and their about $12. I like the straight wheel over the wire cup wheel... seems to last longer.

I clean the panels and then spray all the seams and into all the channels with Ospho (phosphoric acid) which is a rust converter. I hand brush all the seams with Por-15 (I painted the bottom of the tub and inside all 4 fenders with Por15) Then I sand and spray a high build epoxy primer on each peice I finish. When I have enough to put together I spray 2 coats of paint before I assemble.( I hope to have one last coat sprayed at a body shop when I'm done).

I'm hoping to drive the 40 when I'm done and Pennsylvania's road salt is the worst
 
RedGreen said:
where do you find the wire wheels? I've only seen the ones at HD that fit the bench grinder. They never seem to have wheels that will hold together at 12,000 rpm. Looks great though. Makes me want to get out to the garage and start working on it.

Do you spray it with primer as soon as you finish each piece? Or do you just use some Rustoleum until it's ready for primer and paint?

Thanks.
There is a product from Eastwood called metal wash , I have been using it on my cruiser it's excellent to protect bare metal after stripping it is supposed to be a degreaser as well but I don't think it works that well for that purpose but it forms a coating after it's dry that stops flash rust . A similar product from http://www.zero-rust.com/
cost less and yield more seems to be about the same. The eastwood stuff has worked out well for me but I am switching to the zero rust primer and metal prep for the interior.
I did the frame and suspension with rust encapsulator but want to try the zero rust stuff for the tub
 
Back
Top Bottom