Ignitor for a 78' ????

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 25, 2005
Threads
205
Messages
1,768
Location
Hagerstown MD
Anyone had any experience with these? good bad or otherwise. I've got to install this thing and frankly am concerned as it's quite old and looks like it's been laying in a field for 20 yrs.

I'm not sure if I can test this thing or not. If this thing doesn't run, I'm considering using a DUI disty setup that I got w/ the vehicle. PO used it.

Any thoughts on the DUI thing?
 
ignitor

cant test them hook it up if it works it works. these are year specific. What I did.
I trashed the ignitor and went with a non-usa distrib. which is about 300 bucks works great with a weber.
 
I just got done junking my ignitor for the DUI. Was having too many intermittent electrical problems and went with the ease of the DUI. Took 20 minutes to install and one wire to hook up. Cleaned up the look of the engine bay and can't complain about the performance. If you go with the DUI, you can open up the plug gap to 50-55 thousandths too.
 
The ignitors are not year specific. All of the units '78 - '88 will interchange. You can also use one out of a electronic ignition mini-truck. There is a Dodge unit which will work too.

You have to use a fully elecgtronic dist with the ignitor of course.

It only need to be connected to the dist (one plug) and to 12V (one wire/plug). It's just as quick to hook it up and see if you get spark as it is to brench test it.



Mark...
 
thanks for the help on this, So a mini-truck unit will work as well as a Dodge unit? any idea what year and model trucks?
 
The minitruck ignitors would be for any 20R, 22R or 22RE engine....from 1979-1992 for sure...two or four wheel drive truck or 4Runner....



:beer:
 
Sweet, maybe I'll just cannabolize my 80's 4runner then drop in a vortec!
 
Back
Top Bottom