I need help.....

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 28, 2005
Threads
158
Messages
3,567
Location
Atlanta, GA
i just bought a 71 fj40 which has a 77 2f in it. the fj has been parked for 4 years because the PO said the fan blades broke and he parked it and never went back. i looked at the motor today and all that is there now is the pulley which is not bolted in place and just loose. so my question is what do you guys recomend i do at this point? go back factory, ugrade you tell me. i am a newbie and this forum is for learning, so i am asking for advice. and don't say search b/c i have done that and you could spend a life time looking for the answers that you guys can give with ease. so i am looking for some help, thanks.
 
If I understand what you are saying is:
There is no fan.
Only a pully on the water pump?

Recommendation: Put a 2F plastic(?) fan on it. The 2F fan puts out more air than the stock 71 metal fan. I have that setup on my 1973 FJ40 with 1975 2F. Works just fine. I don't know if there is room for a 2F clutch fan?
 
How about we start here:




Do you know if the engine will turn over? Have you tried to do this, either by putting it in top gear and trying to roll the truck, turning the engine over by hand, or attached a battery and see if it would spin over? If the engine is stuck, there is no point in progressing further. Judging from the pictures that you have posted out here, you have picked up a couple parts trucks that are really rough. Hopefully there are parts on these that you will be able to use, as trying to bring one back to life could end up costing you a significant amount of time and money.





There are very few Previous Owners that I would believe ANYTHING that they tell me.




Oh,

You are not above searching. I do it ALL THE TIME.


Learn how to use it. It is a very valuable resource that EVERYONE has the privilege to draw on. You are not the first person to have purchased a Land Cruiser and have a question bud. Invest some time in your desire to learn and do not expect anyone to spoon feed you, as you may find yourself starving for information.



Good luck!


-Steve
 
There is a part to this that makes me think otherwise, I have been twisting a wrench for a very long time, busting a fan? a steel fan? how high does that have to rev to bust? and NOT take the radiator with it? I have seen that only once in my life and that was because a cat was sleeping inside the fan shroud when he started his truck, slicing and dicing the cat, the fan and the radiator.. I am cynical when buying something from a PO who has let something remain sitting for the need of "just a fan", I think that is best called a LONG SHOT!
 
Last edited:
The steel, four blade Land Cruiser fans are known for cracking. While I have not had one fail on me, I have seen them crack, and have also seen the effects of a blade fracturing at speed.

I was lucky to have a water pump bearing fail and snap the water pump shaft at 2500 RPM, sending the fan and pulley into the radiator, destroying the core and the bottom tank.....At least it went down and not up through the hood.


:beer:
 
mine broke at the point wher the 2 blades are pressed together.
so 1 of the four blades (if you will ) came off tokk out my Radi in the blink of an eye. no damage to hood. "I wanted to replace cooling system any way" is what I told my wife. did no good 50mi out on a camping trip.
 
Back
Top Bottom