how much grease in front hub?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 25, 2007
Threads
67
Messages
591
Location
Winter Park, CO.
Howdy all,

I am doing a lube change on my rig and want to put some grease in the front hubs. I know where to put the stuff in, but I am not sure how much to add. Is it a just shoot some in til I think I have enough? Or is there a sign to look for? I looked around the site to no avail. Any info is appreciated.

Thanks, Dace
 
Are you refering to the front knuckles via the square plugs? If so and they haven't been done in a long time or your don't know when, add at least one full tube per side of Moly fortified grease; like Valvoline Synpower or Valvoline Palladium (found at NAPA). You can then drive it for a week and check to see if they need more as it will get spread around. When mine recently got real dry it took two tubes per side spread over two weeks. Twenty years ago I asked a Toyota master mechanic this same question; he said to pump it until it came out the top, then turn the wheel 1/4 turn, repeat,, 1/4 turn, repeat until you have completed the circle. While you're at it, you could clean up the balls/knuckles by hand using papertowels and PB Blaster. I spray it directly onto the felts and then run a thin dull plastic scraper along them to get some grit out, then wipe them down (my technique). If they are a tad rough/rusty, you can clean them up with something like a 3M Scotchbright pad or fine emery cloth.
 
Last edited:
yeah, I mean the knuckles via the square plugs. The front axle (seals, etc...) was done about 15K miles ago. I suppose I'll shoot for a 1/2 tube to full tube per side. I think my big fear was putting too much (if it is possible) in there and blowing out seals and stuff.
 
Ok, so if you had the complete front axle service (around $1000+), then you are not behind in maintenance. Assuming they were properly packed with grease when the front axle was done, then as you say, 1/2 tube per side will probably do it. IME, if you completely pack the knuckles you are more likely to get grease either forced into the axle or sucked in. Meaning, if the front axle breather is not working or plugged, the axle can actually develop a lower pressure inside than out, causing grease from the knuckle to be sucked in, at least that is the theory. I recently pulled down my breather assembly and cleaned it and the hose completely to ensure it was not plugged. Some mudders remove the stock breather and extend the tube high up into the engine compartment and instead of a breather valve, add a small filter on the end. This ensures the axle breathes easy and also helps keep water out of the axle when fording streams.
 
Back
Top Bottom