Hot Or Cold 02 Sensor

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

The O2 sensor is actually a chemical themometer (accutely accurate) that relayes rich/lean condition to the ECU. The ECU then has got to correct the rich or lean problem. When you have a defective O2 sensor, it can not do it's task, but you would generally also get a check engine light if this were the case. As far as Pre-Heated O2 sensors go, they are generally only needed for use with Headers to get the engine to go into close loop sooner.
 
The #1 thing that will make an engine run lean would be a vac leak somewhere after the TB. A distant 2nd would be, clogged injector/maladjusted valves. An even more remote possibilty would be totally unrestricted exhaust, like an open manifold/header. The O2 sensor would be able to compensate for only so severe of each condition.
When the O2 sensor takes a dump, AFAIK, the ECU will go full rich. OBDI systems weren't designed to be notable sensitive enough to a bad O2 sensor signal and could easily fail to throw up a flag.

Is that what you were after?
 
My problem is, Had a Custom Exhaust System done to her, The shop that did it did tell me that " They werent sure on 02 Sensor placment " So i think the reason she's running so DAMN HOT is the 02's are too far away from the Headers, so the ECU is dumping more Gas in the mixture.:doh:
 
My problem is, Had a Custom Exhaust System done to her, The shop that did it did tell me that " They werent sure on 02 Sensor placment " So i think the reason she's running so DAMN HOT is the 02's are too far away from the Headers, so the ECU is dumping more Gas in the mixture.:doh:
I think more fule would make it run cooler....being ritch...less fule runs hot..being lean....NO?
 
Back
Top Bottom