Home Made Rear Bumper

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 8, 2009
Threads
68
Messages
677
Location
Ambridge, PA
Just wanted to share the rear bumper I made and get some thoughts. I'm not 100% done, I'm going to make a plate to fill the void between the bottom of the tailgate and the bumper.

It's all 6" C channel and gusseted with 1/8" plate steel.
DSC00684.webp
DSC00685.webp
DSC00686.webp
 
A few more....it's a little dirty

Oh and it took me about 8 hours including cutting the rear cross member off, all cuts were done with a 4.5" grinder and sawzall.
DSC00687.webp
DSC00688.webp
 
This is just the solution I have been looking for. I have a similar bumper with no side protection, and have been considering my options.

DSC00421.jpg
 
nice job
I'd like stronger recovery points myself though (if that is what those are intended to be)
 
Well I think they'll hold up, they're much thicker than a chain, and the bolts are 1/2" grade 8 rated at 12,771 pounds each, so I think they'll hold up just fine. But thanks for the sugestion.

Shane
 
Nice job.....any future plans for a tire carrier?
 
Real nice looking.

As for the recovery points, while the bolts may hold up (although i'd be worried about them) I'd be almost sure that a few hard yanks would bend those D shackles or just snap them off. Seen it done plenty of times with some real stout materials.

But you made it and would know it better than any of us so it looks good and enjoy it. :cheers:
 
Nice job. Glad you're not afraid to chop some off the frame rails like most.
 
are you going to add any more quarter panel protection? i was afraid that my kaymar did not have enough protection so i added hoops to better protect the marker and panel.
 
Nice job.....any future plans for a tire carrier?
X2 - I'm assuming that your spare won't fit underneath since the hoist chain is just dangling. I like the way the sides are higher than the rear and the way they blend with the wheel well and flares.
are you going to add any more quarter panel protection? i was afraid that my kaymar did not have enough protection so i added hoops to better protect the marker and panel.
X2 - Did you brace the forward-most ends of the bumper wings to the frame? Looks stout enough to add upper protection if braced to the frame. Bumper looks basic and tough. I like it. ;)
 
Thanks guys, I don't plan to add a tire carrier, I'm building a roof rack for that purpose (I'm in and out of the back for work all the time, it would be a pain) but it is braced to the frame with 1/8" plate that's about 6.5" by 11".
 
Back
Top Bottom