High-Steer Q's

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

890man

SILVER Star
Joined
Jul 7, 2005
Threads
90
Messages
867
Location
Thousand Oaks, Ca.
Ok, I don't know where to ask this so I'll just stick it here. I am planning ahead and gathering parts for a SOA, S/R, FJ60 axle, outboarded springs, scout ps, 4w disc in my pig. (not all at the same time though) Further down the line I plan on dropping a cummins 4bt in there. Which leads me to my question. I know there is Marlin and 4x4labs which are both a little different. Which one of these two setups would be better for clearance issues with the cummins. I like the 4x4labs but the tierod in the rear looks like it may be a problem. I'm not sure where the diesel would sit and how the pan looks.
 
Guess I would go with Marlin and keep the steering in front of the axle, since the Cummins may pose an issue later...

Either way, I would go with the ARP knuckle stud kit from Frontrange...


:beer:
 
If you do the steering arm behind the axle it'll prolly hafta run below the driveshaft (like an FJ80). Oil pan clearance will be an issue. Or, hydro steering will be another option. I'm not a fan of hysteer anymore cuz I think there's just too much stress on the studs.
 
I dont want to go hydro as this truck sees a lot of highway. It is my daily driver but will be seeing a fair amount of trail use when I get this stuff done. Thanks for the advice on the arp studs Poser, I had left studs off my list. If anyone else has any practical experience whith these, please chime in. I guess I am leaning toward Marlin. Is there any other reason to have the tie rod behind the axle other than keeping it out of harms way?

Why does hysteer cause more stress? Larger tires, different geometry or both?
 
There is a lot of clearance over the 4x4labs with a SOA. I think it would be much more of a concern with SUA. Don't know if the 4bt is much lower than a v8 pan, but there is a lot of room to manuver.

Safest bet would be the Marlin set though.

Andy
 
Back
Top Bottom