High speed braking wobble :-(

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 9, 2004
Threads
121
Messages
590
Location
Kent England
I am getting the most violent wobble at high speed hard braking, the steering wheel is going left to right at quite a speed, quite frightening to be honest, at low/normal braking speeds it is sort of quite normal, but can feel some sterring wheel wobble.

I dont seem to having the brake pedal going up and down, but it does feel sort of not right when braking.

would wheel bearing loose cause this problem?
 
What about your rotors and pads? What condition are they in? Warped? That would be the first place I look.
 
Isn't this called the "death wobble"? my 60 does that and since all the spring bushings are shot I'll hope replacing them cure the problem.
 
Warped front rotors is my bet. To test drive it at a slow speed then apply the brakes lightly just enough to provide a drag and roll to a stop. See if you can feel the pads grab and release the rotors.
 
If it's a death wobble, the first things to check is common axle play areas, bolt tightness, bad bushings, loose bearings, etc. On the 80 the most common cause is panhard, ether loose bolt(s) or bad bushing.
 
Put the rig up on 4 jackstands.
Have someone in the cab rock (about 1/4 turn each way) the wheel with the engine off. Hold each steering component for a few seconds and see if there's anything loose. Get a large pair of channel locks and squeeze each tie rod end and draglink end. If you can squeeze any of them, it's bad.
 
I get this also when braking going down a steep hill. It doesn't do it any other time. It feels like warped rotors to me, but doesn't really do it on flat or when braking lightly. When it gets worse or to be a problem I'll look at getting new rotors if that is the issue.
 
by grabbing the top of the front wheels and rocking the car to and fro with the wheels on the ground, I can feel quite a substantial knocking/looseness and it does it when I do it to both wheels.

Better check, Tie rod ends, Trunion bearings and wheel bearings
 
The new rotors and new pads have been on about a year, perhaps it could be them, had a look under the car today while I got a couple of guys holding the top of the tyres and making the push to and fro, could not see any looseness in any of the bushes or track rod ends, but there is def a lot of movement at or around the wheel bearing areas, I am not off work till saturday and will jack the front of the car up on my two new modified jacks on Saturday, see what I can find.
 
Got the car jacked up at the front today and you could hold the top and bottom of the wheel and the bearings had lots of play!!!

I have adjusted the bearings atleast 3 times in last couple of years and used the method stated on the site, also using the fish weighing scales, but think its not a good idea now, it's far better to put the wheel back on and keep gradually tightening up the bearing nut until there is no play in the bearing, which you can easily see and feel, I think it's a far better way to set the load on the bearings.
 
... it's far better to put the wheel back on and keep gradually tightening up the bearing nut until there is no play in the bearing, which you can easily see and feel, I think it's a far better way to set the load on the bearings.

You need to go tighter than zero play, they need to have preload. More like 10-20 ft lb on the nut.
 
Back
Top Bottom