HF1A part-time transfer case normal operation

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 24, 2013
Threads
8
Messages
79
Location
BC, Canada
Can anybody test/tell me if what I’m experiencing below is normal for my 5speed HDJ81 with the part time HF1A transfer case.

When I’m engaging 4WD (electric switch on dash) without the Hubs locked there is a loud grinding noise coming from the transfer case. Lasts roughly 2 seconds then it’s gone. 4WD works. If I have the Hubs locked before engaging the 4WD there is just a click, no grinding at all.

Recently the transmission had to come out for a clutch replacement and when we put it back I have noticed this behaviour. I don’t remember hearing that noise before, but normally I lock the Hubs in advance..

Thank you for your input!
 
If you are stationary with the box in neutral or foot on the clutch it shouldn't make any noises. If you are still rolling it will grind.

With the hubs locked in, you can engage 4wd at any speed as long as all wheels are going the same speed. ( not sharply turning or have wheels spinning )

That grinding noise is doing damage, come to a complete stop.
 
If you are stationary with the box in neutral or foot on the clutch it shouldn't make any noises. If you are still rolling it will grind.

With the hubs locked in, you can engage 4wd at any speed as long as all wheels are going the same speed. ( not sharply turning or have wheels spinning )

That grinding noise is doing damage, come to a complete stop.

If I'm stationary and in neutral there is no noise, only when in gear and rolling without the Hubs locked.
Am I understanding it right that what I'm experiencing is expected (normal synchro behaviour), I should just be careful not to engage the 4wd without the hubs locked while rolling to avoid wear/damage?
 
Last edited:
Correct, you should not engage 4wd without the hubs locked and when moving. With the hubs not locked, the front driveline is not moving. The grinding noise is the engagement of the center diff when only part of the system is moving and the other is stationary. That is why when you do it when stopped it does not make the noise.
 
If I'm stationary and in neutral there is no noise, only when in gear and rolling without the Hubs locked.
Am I understanding it right that what I'm experiencing is expected (normal synchro behaviour), I should just be careful not to engage the 4wd without the hubs locked while rolling to avoid wear/damage?
That is correct. Totally normal. If you want to shift on the fly, leave the hubs locked in.
 
Correct, you should not engage 4wd without the hubs locked and when moving. With the hubs not locked, the front driveline is not moving. The grinding noise is the engagement of the center diff when only part of the system is moving and the other is stationary. That is why when you do it when stopped it does not make the noise.

Sounds logical. Would this apply to a part-time transfer case too? I don't think there is a centre diff in a part-time system. Is there?
 
Back
Top Bottom