Separate names with a comma.
Discussion in 'NC- Olde North State Cruisers' started by mtweller, Aug 19, 2006.
Sprayed the 40 today... fairly pleased with the outcome.
and you are just about going to show a picture, right?
working on it, for some reason upload's not working right
Here's a few
Tha't not overspray on the firewall, it's remnants of that rubber crap Toyota put on the floorborads and kickboards. I used a grinder to remove it with a wire wheel and s*#t went everywhere!
a couple more
Thanks man. I prepped like a SOB, grinded down all the paint, primed, yadda yadda. I pray to God it doesn't peel! After all the metal I replaced and the rear sill, this is the culmination of a LOT of hours!
looks great I need to come by and take a look
Thanks man. I'm tickled witht the finish, I just hope the durability will prove to be good. Come on by sometime...we can have a cold one.
nice job. Looks like I'll be in for the same thing including the sheetmetal
If you want any advice (I learned from a few mistakes) lemme' know. I was brand spanking new to metal/bodywork.
I'll prolly be doing that soon as well. I'll have to hit you up for the advice. when I get a little closer to doing it. Thanks.
I brushed Durabak/Herculiner inside my 80. It's been there for about a year now and no peeling. I did use about three gallons though on the floor and prepped like a SOB too.
chip, one hell of an avatar there bud!!!!
Thanks I kinda like it myself...