help with throttle issues

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 31, 2004
Threads
8
Messages
45
big issue...truck idles fine, but when i add throttle, it starts to surge, i.e., goes from 2000 to 500 and back, at a consistent interval...If i push pedal to floor, no change, engine will not go above 2000 rpm, and once i remove foot from throttle, it stalls please help! thanks
 
sorry it is a 1994 series 80, no mods..i keep it at my weekend house...started it today for the first time in a month, added fuel injector cleaner and it ran perfectly, drove it for about 12 miles, no issues..i proceeded to powerwash the underside, clean the engine and take apart the dash, as a mouse has been taking up residence in the hvac...no chewed wires, mind you, just nests

It ran perfectly...problems appeared after i re-assembled everything.
 
and i did place the wires in the diagnostic port...o/d flashing steadily in 3's
 
Wet connectors in the engine bay from powerwashing? How long has that gas been in the tank?
 
2nd that. If you powerwashed and got water in your dizzy you will have issues till it dries out. If its still icthy tomorrow pull the dist cap and allow to dry.
 
the fuel is 6 mos old, but i use stabil, as i expect it will sit for some time...i thought of the distributor, but the throttle variation interval is exact, and the truck will not rev over 2000, even with foot to the floor( it doesn't break up at 2000, just backs off to 500 or so and back up and down, up and down, with my foot at a constant position on the throttle)...it almost seems as if it is a loop set up by the computer...the o2 sensor by the exhaust looks fine...maybe it is the computer itself, or a sensor?
 
I had the EXACT same thing when I washed my engine. It is wet connectors or distributor cap. It actually does it at 2100 rpm right ???

Here is another thread about water and 2100 rpm limit..

https://forum.ih8mud.com/showthread.php?t=142101&highlight=2100+rpm

I used crc in all electrical connectors and crc di-electric grease in them before re-assembly. I also blew them out with compressed air and it started and ran perfectly when I was done. Good luck keep us updated
 
Thanks! I will try today...LC 80scool board had the same diagnosis...off to buy some CRC!!!
 
Back
Top Bottom