Help wiring through a pillar

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 19, 2004
Threads
107
Messages
340
Location
Lutz, FL
I am needing to wire a dual guage pod and drill a hole in the a pillar to run the wires down. I am quite nervous about doing this and would appreciate all the advice you guys could give. I dont want to drill anything i shouldnt. The hole will be about 6 inches below the grab handle.
thanks
 
Yup...when you remove the A-pillar panel you'll see that there are already holes there that you can snake wires thru. They can be run right down the pillar and come out just below the dash with a little fishing. No drilling required (or recommended)
 
Not sure that mine has the removable panel. It is a 93, but I could be wrong. If it is there how do I remove it? Feel free to elaborate by the way.
thanks
 
Im not sure if there the same , but on a 97 :
Pop the 2 covers on the hand hold ant there should be 2 Pozidrive ( i think , or phillips screws) remove thoes and the hand hold.
Then just pull the panel out.

ken
 
Pretty sure mine does not work like that. Yours just pops off when the handle is removed?
 
No you have to pull , maybe pry a little.
Is there a seam at the top of the pillar panel.
Just grab the seam and start pulling it off.

ken
 
So are we just talking about pulling the fabric off or is there a panel"? Sorry to be annoying.
thanks
 
It's a plastic piece with cloth face.

If you PM me to remind me I have mine apart at the moment and will post a couple pictures.
 
I guess mine does not have the trim piece so I just picked a spot and drilled on through. It worked out well and have all my wires run and I even found a rubber grommet piece on the road to stick in the hole. It is strange that they added a trim piece.
thanks guys
 
Back
Top Bottom