help: vac to manual transfer control

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

cruiserjunktion

Cruiserjunktion@gmail.com
GOLD Star
Joined
May 19, 2005
Threads
733
Messages
6,638
Location
North Florida
I have a 71 fj40 w/ vac operated transfer. I also have a 74 parts cruiser with a floor lever for operating the transfer case from 2 to 4hi & lo.

The po converted the tranny shifter from the colum to the floor.

I would like the addtional floor lever controling the 4wheel drive as well.

I looked under search but came up with nothing for a conversion.

Any help converting my 71 vac transfer selector setup to the 74 style with the lever on the floor will be appriciated

thx

mel
 
Mel, I did it and it was all bolt-on. The hard part was cutting the hole in the hump in the right place.


GL

Ed
 
So you were able to eliminate the vac control knob,underdash lever selector, & related bits pieces from under the hood with the floor tcase lever out of a newer fj? Did you use a newer tranny hump with 2 holes? Do you have a pic of your tcase selector? I am not too sure about the location of the new lever. While viewing from underneath, it looks as if it will be coming thru the floorboard, not the hump. Thanks in advance.
 
i was woundering if you do this conversion, do you only get 2
hi and 4lo?? because factory vac. shif on a 71 lets you have 2hi 2lo 4hi and 4lo?? you should at least be able to get 4hi also right??
 
All you need is the newer linkage and the operating rod with housing bolted to the side of the newer transfercase. All of the parts will swap over, but watch for the difference between three speed and four speed transmission transfercase operating rods. You won't get 2lo with the full bracket/shiftgate from the new shifter unless you modify or eliminate the bracket.

This is one of your easier changes. Get energetic and build yourself a twinstick shifter for solid positive engagements and a hi cool install.
 
Tranfer shifter

I did this conversion about 2 mo ago it was really simple the hardest part was putting the hole in trans hump in the right place. Everything else is bolt on. If you need some picks let me know and i'll krawl under the 40 and fix you up. By the way i got my parts from cruiserco (www.cruiserco.com)in Little Rock, Ar. they are some really good guy to deal with.
 
1974, is this not 4 speed linkage? Will it work with his application? I assume he is using the three speed case. If he is using a 4 speed then this post is obviously worthless.
 
Back
Top Bottom