Help mounting control pack on M12000....

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 3, 2006
Threads
148
Messages
1,888
Location
Sonoita, AZ
Website
olc4x4.com
Installed a new M12000 on the 80 series ARB today, however I don't like the idea of one cap screw holding the control pack to the winch.
Warn included two large hose clamps but I can't see a good way to attach the control pack to them & the instructions are of no use.

I'd rather not move the control pack under the hood but I can't see an effective way to mount it to the winch...
Maybe I've been working on it too long an am not seeing something obvious.


Ideas?

Thanks
 
The control box mounts fine to the winch. I have an m12000 on my arb and it was all pretty obvious how to use the hose clamps to mount the box.

Unless you are desperately inept, it shouldn't take much to figure it out - less time than it would take me to go out to the 80 to take pics and post them here....

HINT: the ARB should have come with a bracket thingy that you need to use on the bottom of the box and the 'tab' part of the bracket is then captured by the 2 hose clamps to hold it to the winch... I "think" the bracket came with the ARB & not the winch - but can't remember - been like 13yrs+ so since I installed both.

cheers,
george.
 
Last edited:
Ok, feeling generous, here's some pics that should make it all obvious... ASSUMING you have that bracket...

m12000a.jpg


m12000b.jpg


m12000c.jpg


cheers,
george.
 
If it was a new ARB, there should have been a package of brackets and bolts in the big box/crate. In mine there wasn't, worked things out between the vendor and ARB without an issue, can't remember whose fault it was at this point. Anyway, that could account for your missing hardware.
 
If it was a new ARB, there should have been a package of brackets and bolts in the big box/crate. In mine there wasn't, worked things out between the vendor and ARB without an issue, can't remember whose fault it was at this point. Anyway, that could account for your missing hardware.


Ah ha!
Must be it.
Thanks!
 
Was linked from another thread - if you want to drop the relay box another 3/4" or so, the 2nd & 3rd pic of @george_tlc show the way I have mine.

You can use those 2 ears on each side the relay box baseplate & just hoseclamp it directly to the motor end - you can see in his pics how the ears have the curvature to match the motor & it is a sound connection with those clamps tightened w/ a 3/8 6pt socket.
 
You can also make a super simple bracket out of some 3/16 or 1/4 bar stock. It can be pretty much a straight bar with two holes in it. One bolts through to your ARB the other to the solenoid pack. This is how I ran mine back when I had an ARB bar across the front.
 
Back
Top Bottom