HELP Getting Codes PO300 & PO304

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 13, 2006
Threads
138
Messages
843
Location
Tierra y Libertad
OK, I am a bit bummed out on this. My 97 FZJ80 is running a bit rough, but drivable. I have noticed the symptoms around 3 days ago....Engined running a bit rough between 1-2K RPMs during acceleration and some times when idling.... Last night the CEL came on...and stayed on.... I pulled codes this morning and got PO300 and PO304 for #4 cylinder misfires....which is consistent with the symptoms I was getting.... A brief search yields me to look for a bad FI wiring hardness....and to look from the EGR Valve to the ECM..... The Fuel Filter, Cap and Rotor were replaced about 10,000 miles ago....The engine has been kept dry except the occasional rinsing inside the engine bay that I do for cleaning purposes.... Any harm in driving like this for a while Until I either 1. Take the car to my local mechanic or 2. Trouble shoot the problem further myself? Do I run th risk of getting strandred if I continue to drive it like this in the mean time?
 
What is the best way to check the engine wiring harness where it passes by the EGR tub at the back of the cylinder head????? What tools do I need to tackle this?
 
what color is your exhaust smoke?

hate to be the rain clouds, but the P0300 & P0305 were the codes for my failed headgasket.

If you can spend a good half day with maybe two bananas worth of skill you could switch out injector #4 with injector #5 and see if the problem follows the injector....

as for tools. I have a pretty basic craftsman set, just make sure you got the 12 and 14mm sockets. get yourself a good two feet worth of extensions for the bottom of the intake...


its that easy :D
 
The Color of my exhaust is what is always been. I haven't changed the spark plugs or cables....The plugs looked pretty good when they were checked last at 18K miles...

I don't think it is the HG, the car has never overheated on me, and there is no indication of me loosing coolant, or having water mixed in the oil, or white smoke coming out of my exhaust....

Q: What is the best way to get the engine wiring hardness by the EGR valve? What needs to be removed? Yesterday I check by the ECU behind the glove box and everything looks fine...
 
Remove the hose from the air box to the throttle body, remove the throttle body, loosen EGR union nut, and remove nuts on EGR mod. You will have good access to the wiring harness at that point. To make it easier on yourself remove the air can to give yourself some room.

or....


call your local Toyota dealership and get a qoute for an injector service. My local dealership (American Toyota :D) has a special for 89.95 (I think) see if that makes the problem go away.
 
Well,

Yesterday I took the first step and finally changed the spark plugs...But I did have a mishap trying to take out the no. 6 cyl. plug.....I broke the top portion clearly off and ceramic pieces got knotched in between the plug and plug chamber....pain in the A$$$....I was unsuccessful at extracting the broken plug myself...so I hired the assistance of a mechanic (friend of a friend) to help me out of the jam....:mad:

After a good effort the plug came out with no noticeable thread damage, a new one was put in and the truck is now running smoothly again, with no idle problems so far....hope it stays that way. I do need to change the plug wires though as they appear to be the originals (stamped 1996).....
 
Back
Top Bottom