Heater won't work on high

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 19, 2008
Threads
15
Messages
40
Location
Western WA
I have a 91' LC and the heater-fan will only work up to position 3 on the switch (moving the switch to high makes the fan act as if its on low)..


I thought it may be the switch, but sometimes the high does work (seems to work better if the LC is really warm)...

Any ideas?
 
Well first thing I think I would check is the connector to the fan under the PS seat. Make sure all connectors are clean and not corroded. Takes 5 minutes to take off the seat. Its just (4) 14mm bolts and one electrical connector IF you have power seats.
 
Sounds like my HVAC. Except the 3rd position acts like Low. So I have "Off-Lo-Med-Lo-Hi"

:lol:
 
Well first thing I think I would check is the connector to the fan under the PS seat. Make sure all connectors are clean and not corroded. Takes 5 minutes to take off the seat. Its just (4) 14mm bolts and one electrical connector IF you have power seats.

Wouldn't that be for the rear-air?
 
The fix is just to replace the resistor with a new one. Not sure exactly where it is located on the 80 but it is usually under the dash on part of the heater ducting/blower assembly. Someone in the know could pipe in.
 
The resistor has no effect on the high speed blower setting on these rigs. There is a separate relay (blower high relay) under the drivers side kick panel in the relay set that is there.
 
Back
Top Bottom