Heater core bad??

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 4, 2006
Threads
636
Messages
23,860
Location
Buckley, WA
I have zero heat comming from my front heater, my rear heater still heats up. The valve on the fire wall (water control valve it think it is called) had been bypassed by the PO (i'm guessing it wasn't opening for him), so coolant has to be flowing to the heater core. I just get air out of the vents that is whatever temp it is outside. I'm going to try and flush it when it stops raining but i'm thinking that if it has no heat comming out then it must be completely done for. Anyone else get this???
 
Both the inlet and outlet for the heater core are on the firewall. One is on the right side of the engine (looking at it from the front) near the heater valve. The other is on the left sid ef the engine. I think the top hose on each side is the for the front heater. You may want to disconnect each hose and use some LOW pressure compressed air, and pressurize one side and see if either air or liquid comes out the other side. If nothing comes out, it is probably plugged. Below is a link to my thread about unplumbing my rear heater. It has pictures showing the connections on the firewall. Since your rear heater is still plumbed, don's mess up the hoses while removing them.



https://forum.ih8mud.com/80-series-tech/175120-please-confirm-un-plumbing-rear-heater.html
 
I flushed the heating system and at first a bit of rusty type water came out and then it was clear. I did this for about ten minutes. Turned on the truck let it heat up... turned on the heater.... cool air again. :mad::censor:
 
Check the thermostat.


No, he said his rear heater works! How is the heat valve bypassed? It controls both front and rear heat systems. If it's bypassed you should be getting constant heat (can't turn it off) to both systems when engine is warmed up. Get your rig up to normal running temp and feel the hoses for the front heater between the firewall and the junction with the hoses from the rear heater. They're short hoses, but you should be able to feel if they're warm, hot or cold. If it's not hot, your problem is the heater core or the junction fittings causing some kind of restriction to keep heated coolant from taking that route through the system. Try taking junction fittings out of the loop and bypass your rear heater temporarily, and just plumb the front heater. If you get heat to the front that way, retrace your steps to find the blockage. Why and how the heater valve is bypassed has to be the key to your problem.
 
T-stat is fine.....
I've got heat now. I had to forward and reverse flush it for about 30 minutes each but that seems to have cleared it.
Thanks for all the help and answers.
 
Back
Top Bottom