Headers for my 72fj40 with 77 2f engine

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 13, 2005
Threads
23
Messages
94
I saw an earlier post that downey headers were the way to go. I have a 6 to 1 set on the blue beast now and they are kinda rusty. My exhaust is a joke so I am going to get a local shop to make me a new exhaust setup and figured I should just go ahead and replace the headers while I'm doing that. Is downey still the way to go? Should I do ceramic or chromed? How much longer do ceramic really last? Thanks for the input?
 
I really liked my headers from Downey. But I think the 3 in to 2 in to 1 form is sold by others as well.
 
downey with 2 pipes

Does anyone run the MAF 6 to 2 with dual pipes all the way back?
 
I run a SOR two piece header and toyed with the idea of running dual exhaust, but there is damn little room to do so if you want the exhaust to fit where it should. Whatever header you end up with it should have the same flange thickness as the intake so you don't have to mess with "half washers" to make up the thickness. Use an OEM or FelPro gasket(or two) and retorque, retorque and retorque.
If in a cold climate you might also consider a fluid heat riser and if you run an aircleaner with the capability of "warm air intake", fashion an adapter to your header to provide that.

GL

Ed

Oh and as to coatings, I'd JetHot them if you can afford it. Solves a lot ov header problems, heat and rust.
 
Back
Top Bottom