head milling

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 5, 2006
Threads
60
Messages
126
Location
Atlanta, Ga
I'm going to replace the headgasket soon and was just wondering what the cost of milling the head would be. I've had some overheating problems so wouldn't it be a good idea to have the head checked anyway(i don't know enough about this part to really know what would go on here besides a visual inspection) so how much would I be looking at for the check as well?

I'm going off of the parts list from the hg dvd so other than those things I'm also going to send the injectors off to rc engineering. For the heater hose part I think i'm going to go for those fancy silicone hoses. I know people to many other fancy things at this point as well but any basic other things i'm missing that are almost must does with 150000 miles?
 
You are definitely prime candidate for HG job, this is your first warning... I suggest you jump on it!

Pressure test for cracks, cleaned, milled .005, new valve seals, valves ground,
$650.00 (SF bay area).

There is a ton of info on the HG repair procedure... and there is also a DVD offered by IdahoDoug. I used the DVD and FSM. Also, get the HG kit from CDan... he can make other suggestions as well... like distributor o-ring... etc.

While I was in there I replaced all the hoses, belts, water pump, thermostat, radiator, fuel filter, fuel regulator, sent the injectors to WitchHunter performance for testing and cleaning, and all new head bolts.

Good luck!

--don
 
Back
Top Bottom