Head is off. Other PM Items?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 20, 2003
Threads
45
Messages
155
I'm in the middle of a PM HG replacement. The head is at machine shop and now I'm contemplating diving deeper into PM stuff. I've got some serious sludge around my oil pump and power steering pump so oil pump seal is next along with the crank seal and timing chain guides. What methods should I use to remove and reinstall the crank shaft pulley?

I'm not seeing many folks on the board replacing the time chain and timing chain tensioner. Opinions on replacing these items too?

Other PM items: front and rear upper oil pan arches, replacing brushes in my alternator and starter, new radiator hoses and vacuum hoses. My water pump seems to be fine but I'm going to replace anyway. Any other PM ideas "while I'm in there"?

Thanks. Doug
 
PHH. Do it, now!
 
I would replace every hose and vacuum line that you touched getting to the head gasket.
 
... and timing chain guides.

Just so ya know, you still have a pretty big project in front of you if you're going to remove the timing chain cover.

-B-
 
-belts
-fan clutch
-thermostat
-plugs, wires
-air filter
-wrap wiring harness around EGR with heat resistant material, I used heat shielding tape
 
Just so ya know, you still have a pretty big project in front of you if you're going to remove the timing chain cover.

-B-

I know...I'm starting to think about just replacing the oil pump seal and not touching the timing chain cover. However, it would be a major m'effer to do it later.

Has anyone had a timing chain component failure (tensioner, guide or chain)?

Thanks for the other suggestions but they have already been covered. So it comes down to if I should pull the timing chain cover.
 
Has anyone had a timing chain component failure (tensioner, guide or chain)?

The early engines (93-94) had a timing chain guide that sometimes fails (separates). We have not had a report that I am aware of on the later engines. There have been a couple of unlucky guys that have broken the tensioner during a HG repair. One of those was Landtank and you can read his thread in the archives.

I have not heard of a timing chain failure on any 1FZ-FE but I don't read all threads any more. Not even close to all of them. You might want to do a search on "timing chain" in the 80-Section. You'll have to wade through a lot of non-relevant posts.

-B-
 
Thanks -B-.

I'll post a pic of my HG tomorrow on a different thread. I can't believe it hadn't already failed! The HG around No. 1 and No. 6 looks BAD. I'm feeling good about doing this as a PM.

Doug
 
Check out beno's "rust belt rebuild" thread for lots of inspiration to help you drain your cruiser fund! He did a lot of while-you-are-in-there type work, and did a nice job documenting it with pics and info.
 
As often as I have been seeing and referencing Rust Belt Rebuild, maybe it should be in a Sticky Thread
 
Back
Top Bottom