Head Bolts- Replace All or No?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 23, 2007
Threads
14
Messages
73
Location
San Diego, CA
Hello All-

Doing a Head Gasket and I'm trying to decide if I need to spend the $12-$14 each for the 14 head bolts on my 97 Lex? Should I replace all now? or should I replace only as needed? I know these are stretch bolts and not sure how reliable they are after re-use.

What do the experts say?

Thanks
-Mike
 
Hello All-

Doing a Head Gasket and I'm trying to decide if I need to spend the $12-$14 each for the 14 head bolts on my 97 Lex? Should I replace all now? or should I replace only as needed? I know these are stretch bolts and not sure how reliable they are after re-use.

What do the experts say?

Thanks
-Mike


FSM has specs for stretch. Check them against the specs. and then decide.

I did not replace mine. They were fine as is.

-o-
 
Mine are at the limit, I'm not replacing them. Fuggit.

I couldn't find aftermarket replacements anywhere. Dealer only. I talked to engnbldr (earlier year toyota guru) and he said that he would reuse them, his books didn't show replacing.

Manual says that as long as you can torque them down to 27ft/lbs initially that they should be fine.
 
Yeah there are only a few vehicles that requires replacing the head bolts. Like some Ford 4 cylinders only get one use.
 
I replaced the TTY bolts in my 95 Runner (3VZE) due to all the possible head gasket problems and causes with non-stretch type bolts so I would have a consistent torque value across the board. There are also aftermarket bolts for that motor available all over the place for dirt cheap.
 
I would definitely check the portion of the bolt between the threads and the bolt head with a caliper.

"Cylinder head bolt outside diamter"
STD - .4272" to .4331"
Limit - .417"
 
I guess I should elaborate- I will check them against the spec when I get them out and replace as needed.
 
Extremely unlikely you'll need to replace. For confidence, either measure them yourself against the spec in the FSM or bring them to a machinist and they'll likely measure them for a 5 spot in about 2 minutes.

DougM
 
Just cause I almost always overdo things, I replaced all of mine with new OEM's from cruiserdan. Different strokes for different folks; no reason to think that they needed replacement, I just almost always overdo things. :cheers:
 
Back
Top Bottom