I've been reading through a lot of the recent HG threads lately I've got a sicking feeling I messed it all up. Hopefully I'm just paranoid and have forgotten what exactly I did when putting the head on. I think I may have getting confused with the first pass torquing the bolts to 90 ft lbs instead of 29 ft lbs then doing the two 90* passes. I know I read the FSM so many times while working on it but after reading one post I just have that sickening feeling I loused it up. Its been about 2500 miles and six months since the replacement and no problems. Would it have possible to torque the bolts that high with out snapping them off? I was using my 1/2 Craftsman torque wrench to turn the bolts the extra two 90* increments and it was very tight. Not sure if they are very tight when torquing to 29 ft lbs but I remember putting a lot of effort into the last 90* pass. If this is the case what kind of failure and when could I expect it. I hope this is not the case because I feel really dumb right now 
Last edited: