HDJ81 electical problems

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 20, 2006
Threads
13
Messages
41
Location
Chiba Japan/ Richmond BC
Hello,

I was wondering if anyone out there could advise me of how to tackle this situation:

My friends 1990 HDJ 81 started having problems with the drivers window slowing down then finally cutting out. Immediately after the car wouldn't start. Jump started it...and the window worked but seemed like all the other windows were working slower than before.
Knowing that at least the window wasn't right..it was left up thereafter..but then the truck wouldn't start again. So tried to see if the battery would hold a charge..No..so a new battery. (just replaced one of two) Anyways..it worked for a few days..again it wouldn't start...So is it the altenator pehaps? And if so..is it a serviceable item or does it need replacing when it begins to act up? And is there a cross-over part wise with something available readily here?
And finally..how do the wiindows play into all this?..(thinking out loud)..grounding issue?

Thanks for any input

Bakasan
 
First I think you should measure the output of your alternator secondly I believe you should always (correct me if I'm wrong) change out both batteries, as it's kind of like changing one battery in a flashlight . The 81 has a 24v starting system and both batteries have to be up to the task. The windows on the 81 seem to be kind of wimpy, my passenger side window mechanism i've taken completely apart cleaned and lubed everything but I still know not to open more than 1/2 way when it's wet out. I wax the weather stripping to reduce drag and that seems to help to some degree. Good luck Tony
 
Lack of power will manifest itself in many different ways, such as starting and, as you encountered, window trouble. Anything with higher power requirements.
BTW, try some lithium powder in the window rubber for that one, even after the electrical trouble has been resolved.

Test the alternator first. An easy but not fool-proof way is to disconnect the batteries while the motor is running; if it dies, the alternator (or a wire in its circuit) is toast.

Test the batteries second.
If you have to change batteries, do both, not just one.
Also, they have to be identical.
Have them tested before you buy, as chances are there will be small variances even within the same model line.

If both the alternator and the batteries are good, get assistance reading the multimeter as you fiddle with the wires feeding the alternator as it could be an intermittent open or short that did not show up in test #1.
Because a possibility could be an intermittent short somewhere in the alternator circuit causing a drain, and that would be the most difficult of all to find.

In terms of battery longevity, maybe a power converter aka battery balancer would help. I'm still not on board with that idea, but maybe others could be of greater assistance. Also, others will be leaping in to correct me should my advice be incorrect.
All I can say is this methodology proved itself with my BJ42. I never even had to investigate the funny blue fuzz growing off my fuse terminals.

Good luck,
 
Test the alternator first. An easy but not fool-proof way is to disconnect the batteries while the motor is running; if it dies, the alternator (or a wire in its circuit) is toast.

A diesel won't care if the alternator is toast. No spark plugs.


Remove the alternator and take it to a place where they can test it, usually a chain store like Autozone.
 
In my experience you should not change a single battery on a TLC that runs 24v (yours runs 24v on the starter side). If one is weak it will kill the other. I had the same experience you are describing on my bj42. I replaced one battery, then replaced the other shortly after. Not long after that the second new battery was dead. I fixed the problem by using the correct step down voltage regulator for my radio and buying two new batteries.

Karl
 
Test the alternator first. An easy but not fool-proof way is to disconnect the batteries while the motor is running; if it dies, the alternator (or a wire in its circuit) is toast.Good luck,
DON'T disconnect the batteries while the alternator is running, the voltage spike can fry the regulator and other electronics.

Very low volatge can be a sign of worn brushes, very high or very low, a faulty regulator. A humming or otherwise noisy alternator (apart from bearing issues) can indicate a faulty rectifer.

A good battery will be able to sustain a load with little voltgae drop. If it drops instantly under load from a nominal rest voltage , the battery is probbaly worn out (no capacity).

Bad wires can cause this, but you can identify them reading the voltage drop from the battery terminals. Often it's simply a matter of cleaning connectors.

HTH...
 
Back
Top Bottom