Hand throttle

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 23, 2004
Threads
43
Messages
209
Location
Ride in VA now in NOVA
I’ve searched the forum but didn’t find anything that applied to what I’m thinking so...
I have a v8 conv. in my 76' 40 so now I have this choke line that is just sitting there and I was thinking, lets make the damn thing do something. So I’ve decided that a hand throttle could be of some use in the future.

The problem is even though the line makes a straight line to the Holly carb I’m not sure how to link it to the throttle linkage so it will still allow the foot pedal to operate normally!

Does anyone make a two-line spring linkage for a holly carb?... or anybody have an idea of how I can make one?

Peace
 
Did this once, did not work well, the factory choke cable is not precise enough, it would never set where I wanted it, almost every time too much gas......install a 10 speed bike shifter, route it under the dash to the top of your pedal....
while you are at it throw the Holley as far as you can......... :flipoff2: :flipoff2:
 
I bought a T handled one from a local parts store. You turn it to sinch it down to hold it in place, I think it was about $20.00.
Here are a few pic's the first being the T handle, Second is the way I have it routed, Its a stiff metal wire that just rests on the throttle linkage, I bent it into a hook, I havent had any sticking or falling off prob's...Yet, its been like this for a few years.
Good luck
Sorry for the poor pic's, Its dark in the garage
 
Last edited:
so brian, when you are using the throttle pedal, does the hand cable not move at all...i've always wondered about hooking up to the carb and how to keep the two cables from fighting each other.
 
Ige. When you push on the peddal it pulls the linkage but because the TH has a stiff wire it stays put and slides on the nut thet holds the throttle cable...Make sence?, Im trying to figure out how to describe it. However if you use the TH it pulls the linkage.
Hope that helps
 
nuclearlemon said:
that would be a vernier cable...you probably got one just like it in that volva you drive. how'd you hook it up steve?


volva....nice.... :)

acctually, that is an electrical engine...no cable in '96 only wires...

I thought you knew your vulvas....





Cable mounts to lower left side of dash, below pad, on a modified, but supplied bracket, cable routes through bulkhead, is secured with an Adel clamp on one of the brake master cylinder mounting studs, I cut the cover back, cut the cable off longer, bent a loop in it to secure a little chain with slack in it so that the movement of the throttle is independent of the foot feet, and attached it to one of the many fine options on the throttle linkage plate that exist from running that Weber 38...




Klear as mudd???





I will get some pics someday...dig this up, and post em.



Good luck!


-Steve



You could proably get everything that I have described here from a hydro/PTO supplier in Denver for under 50.00....if not, the chain is similar to what comes with 4' fluorescent lamp fixtures...
 
that's how some dude on the k5 board does it.

i know my vulvas??? hell no...i deal with the big three truck mftrs...not the wanna be trucks :flipoff2:

freightliner/pete/kw are all electronic now too
 
thanks vitesse

I think I can go low tech and just drill a hole in the pin that the throttle cable is mounted to. That way I can slide the old choke line thru it and put a wire clamp on it. I think the line is stiff enough to allow the linkage to slide past.

Peace
 
Back
Top Bottom