hand throttle install

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 20, 2014
Threads
5
Messages
31
hi guys. I just bought a hand throttle cable kit but didn't get any install instructions. has anyone here put this on their 80. they're all factory Toyota parts so should be some kind of instructions somewhere. thanks
 
thanks I've seen some pics on here but no real instructions. I could prob figure it out with pics but it's always nice seeing the correct procedures.
 
As others have said, it's a very simple install. Removing the lower dash trim helps. On the very top of the accelerator (opposite where your foot goes) there is a wide, flat spot. I had to create a notch and open it up with a file on mine to accommodate the plastic grommet on the end of the cable. I have read that others found this notch already existed on their pedal. Have fun!
 
Just did this today with this kit available on ebay. Thanks for the link to Slee's site for the instructions, @greentruck! It is relatively simple once you understand how it operates. But, for the installation, first you need to drop the lower dash (4 screws - no big deal). And second, it helps considerably if you are young, skinny and a contortionist. If you are all 3, then hell yes, it's easy....the less of these 3 you are, the more difficult it becomes. Also, although Slee's instructions help, they are kind of incomplete, at least for understanding the adjustment (steps 3 & 4). It is not explained how the part they call the "cover", comes apart and allows the adjustment they are talking about. Otherwise, you are left wondering - adjust what?! They point out the adjustment screw, but if you try turning the adjustment screw without popping the cover open, you will strip out the plastic "innards" and render it useless. The pics are helpful and excellent warning about if it's not adjusted correctly, it can affect the idle speed.
 
Just did this today with this kit available on ebay. Thanks for the link to Slee's site for the instructions, @greentruck! It is relatively simple once you understand how it operates. But, for the installation, first you need to drop the lower dash (4 screws - no big deal). And second, it helps considerably if you are young, skinny and a contortionist. If you are all 3, then hell yes, it's easy....the less of these 3 you are, the more difficult it becomes. SNIP

You're welcome.

I'm getting so it's not just under the dash where I'm having trouble meeting all three factors, but we persevere. :flush::wrench:
 
Back
Top Bottom