Grinding noise on deceleration?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 27, 2019
Threads
8
Messages
71
Location
Grand Coulee, SK, Canada
Hey, if anyone has an idea let'er rip, I'm pretty new to Land Cruisers so any help is appreciated.

So, here are the symptoms. Everything is fine under 20mph. When accelerating things are ok, I have a bit of a shake but I just did a 4 inch lift and don't have shims yet so I'm chalking that shake up to caster. However, on deceleration over 20mph I get a grinding noise, even with the clutch pushed in..... any ideas? I'm going to check transmission fluid tomorrow, I did top up the transfer case the other day.
 
Assuming you didn't have this issue before the lift and you are in 2 Hi? U-joint/driveline angle issues?
 
Ya, might be driveline. No I didnt have the issue before. Definitely in 2 hi. Basically I just want someone to say, "it's not your transmission" lol. My pinion angles are certainly off after the lift, I hope its ujoint or driveshaft related but sounds a lot like gears grinding. Thanks
 
Are hubs locked? If so maybe front drive shaft rubbing on armor plate. Also check tightness of engine mounts.
 
Thanks guys, appreciate the help. Now if I could just find some shims without paying $40 shipping and $25 duty I'd be in business lol.
 
Gentlemen!! Great news. I thought I would report back that all of this has been fixed. I took apart the rear driveshaft and the PO had installed it misaligned, also the pinion nut and transfer case nut were way out of torque spec, too loose. I also greased everything and my vibration and grinding problem is gone. Thanks for the help.
 
Back
Top Bottom