got pipe?

[yotawheeler]

anybody have any 3 1/2" OD pipe? i need some for my sag conversion and i bought some that was 3.5 ID and its too fricken big...which means that i cant finish my sag conversion this weekend....if anybody has any i would love to take it off your hands...i just wanna get 'er done. cause my winch needs some TLC and thats gunna wait until my truck is drivable again. thanks guys.

 

[seapotato]

I had a look, thought I did have some but no luck.

you only need 2 or 3 inches right? can you cut a little out of it and give it the squeeze in a vice to get it back to round ? ( wouldn't take much with a short length like that. )

 

[yotawheeler]

yea...no i was going to run it right through....about 4 1/2 long...but i hadnt thought of doing that though....i might give it a shot. its screwed anyways...could be interesting though...its kind of a heavy wall pipe. thanks though for taking a look

 

[yotawheeler]

got that to work today....cut a chunk out of the sidewall, heated 'er cherry red in the forge (tried using just the vice but schd 40 pipe is a bit beefy to do that cold) and closed it up in the vice....not %100 round but close enough i think...