Got a Taurus Electric Fan today, what sensor?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 17, 2005
Threads
74
Messages
571
Location
Tucson, AZ
Okay, I've used the Hayden kits on 3 cars in the past and had issues with all. I got myself a nice 90 Taurus fan today for $20 and plan to wire it in to my FJ40 with the bigger Napa ST85 relay but I need to know what sensor to use? I'd like to just tap some threads in the thermostat housing but need to know what sensor to use? What have you all done as far as wiring them in so they go on at the correct temps?

If this goes well I'll give it a shot on my Full Size Blazer as well.

Thanks for so much help and it will be nice to be able to learn and give back a little.
 
I used two of the hayden sensors on mine and they work fine. Use a relay that can handle higher amps than 30. Waytek carries 75 amp ones.
 
I use 40 amp relays with my taurus fan and no issues. I used the haydon adjustable and I did not put a load through it, I use it to trigger the relay. No issues at all so far in well over a year. So that is my $.02 but if I were to do it again I would get one of the fancy screw-in units from flexalite or someone else that sells a comparable unit. Then wire it through that, it has the relays etc all built in...
 
Saab 900 upper radiator hose has a nice TEE connector in it with a thermostatic switch that goes to ground. Simple installation, slice radiator hose, insert tee connect hose ends with clamps, wire sensor to relay.

Kelly
 
Oh s***!

Did I just find out the hard way that there's no easy way to put a Taurus fan in a 74 FJ40 with a 2F motor in it? There isn't enough room as it sits so I would need to move the rad forward at least 1.5 inches. Anybody else running electrics on there 2F or F motor?
 
I will not mention this, but look at ford contour fan.
should be able to fit?

SHHHHH between me and you.
 
Man I sure wish somebody could help me:) Will moving the rad forward or even just the top forward do the trick or has nobody done this? Not a total loss as I can use the Taurus fan on the blazer.
 
I have NOT done this to an F or 2F engine, but it is hitting me in the back of my head that you need to move the rad forward an inch to fit it. IIRC it isn't that hard to move it either. It is even an option, moving the rad, when installing the SBC if you don't have room. Could be blowing smoke, but that sounds right.
 
Back
Top Bottom