Getting around on 35"s

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 3, 2006
Threads
259
Messages
1,935
Location
Fort Apache: Victoria
I did a search and there's lots of opinions on how much lift you need to wheel on 35s, but I have a slightly different question.

I have a lead on a really good, really cheap set of 35" by approximately 12" wide tires. I can't afford to do my lift until late February, and I don't have anywhere to store the new tires until then. If I buy them, I havt to install them now.

So, my question is: can I do normal daily driving on a non-lifted 80 equipped with 35s? No wheeling, no articulating, just highway and city driving. Will there be rubbing? Do I risk tearing the inner sidewalls on something? I'll be using stock 16" wheels.
 
No off-road? Possible, but you'll probably hear rubbing if you turn into a steep driveway or hit a speed bump just wrong. I don't forsee any majory damage, and to eliminate all issues, you could go ahead and buy 2" bump stop extensions for the rear (where the rubbing will occur, the front end wont compress enough to stuff a 35 even with stock bump stops).
 
BTDT, yeah I ran 315's for a few weeks on the stock suspension of the LX450. You may rub on something but nothing to be worried about if you're not off-roading.
 
I have a lead on a really good, really cheap set of 35" by approximately 12" wide tires. I can't afford to do my lift until late February, and I don't have anywhere to store the new tires until then. If I buy them, I havt to install them now.

So, my question is: can I do normal daily driving on a non-lifted 80 equipped with 35s?

I wouldn't; not because of the 35" diameter, but because of the 12" width.

If you need a place to store a set of 35s for a few weeks, PM or email me your phone number. Also, if you become tempted to change out your stock wheels, please keep me in mind.

-Steve
 
I read somewhere that someone on here ran 315 nitto terra grapplers w/o any lift. They said that 35" were able to fit within the wheel wells, but yeah you would not want to do any offroading with that set up. I would go for it and if you rub i dont really see that being worth stressing over, just spray some rustolium under there if you do infact rub a little. But what do i know ive only read about it, I lifted mine the same time i put the tire on...
 
My 12.5" wide 35's stuff with minor rubbing on the frame in the rear. My axle has to articulate a lot (putting the tires at an angle) to get them stuffed, so I'd guess you'd get less rubbing without a lift. Your worries would most likely be while turning.

-Spike
 
i believe codyrx7 ran em for a while before the lift on his LX.
 
Brother Rob ran Nitto 315's on two stock trucks before installing the lifts, street driving only. The only issue was the rear tires sidewall to wheel well rub on big bumps, no damage to the truck or tires.
 
Back
Top Bottom