Gears

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 9, 2006
Threads
101
Messages
513
Location
Alpharetta GA
Finally biting the bullet and paying a shop to setup my gears. I have had those pretty Yukon boxes and Mr. Yota's sitting idle too long. A 4wheel drive shop I used to work at years ago is doing it for me. I am still friends with the manager and he said he would have the shop foreman do the job but he is not used to doing toyotas. I'm not very worried about the rear diff but he is going to rebuild the front axle while setting up the gears with, new rotors, 100 pads, all new bearings and felts I got from CDan back in Sept. Now my friend says he has built yota axles before and sami stuff which I guess is similar, but should I be concerned? Is there anything that I should bring him or provide to make sure the job is done right the first time. I don't want to insult the guy because he has been there like 5 years but just a little concerned. Help me out, I'm always too paranoid.:hillbilly:
 
One thing which I read about the gear swap that stuck in my mind is to make sure they specifically use the Toyota shims.

One member did a rebuilt himself, and had to do it over because of this. I can't recall exactly what the difference in the Toy shims was, but evidently it was rather important.

IH8MUD.com Forum - View Single Post - Should a shop do my gear change
 
Last edited:
WARNING: A friend of mine here on Mud had his done at a local Toyota specialist where all techs are "factory trained". They f'ed up his front end, and wouldn't make it right. He is spending another pile of cash to get it done properly...

If you have any misgivings, I would at the least, have a serious chat with the tech who will be doing the work. Personally, with the few options I ahve nearby, I would pull my 3rd members and send them to one of the reputable Mud vendors.
 
I would pull my 3rd members and send them to one of the reputable Mud vendors.

If and when I regear, that is the route I'm going to take as well. Haven't decided yet if I'm going to send both 3rd's at the same time, or one at a time to keep it driveable.
 
Haven't decided yet if I'm going to send both 3rd's at the same time, or one at a time to keep it driveable.

Lakeville, MN is only a few hours away. Give Poser LC4WD a call. Having him setup my gears was worth the trip from KS.
 
Thanks for all the reply's! I think I will have a friendly talk with the shop foreman to make sure he is comfortable doing it. If anything I will have him go ahead and setup the rear diff since my front d-shaft is already out and maybe try someone else with experience for the front. If I can help it I only want to do this once for a few years at least. I am dropping it off Sunday so I'll post up after that. Thanks eveybody!:cheers:
 
Back
Top Bottom