Gapping points

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 24, 2003
Threads
208
Messages
2,210
may seem basic, but how do i gap the points on a 2f (dizzy is from a 1976 i'm pretty sure)... what size do i "gap" them to
 
.018 is ussally good.
Turn motor until points are at max open (high point of dissy cam on points)
Loosen base screws.
Put screwdriver in th elittle slot and adjust until gap is correct.
Recheck after tightening screws.

If they're old points this wont work at the points aren't flat anymore - you'll need to do it by dwell
 
The couple times I did it, although it may seem primitive, I just used the flap of the little box it came in. Not a thick piece of cardboard, not as thin as paper. As long as it opens some I just called it good and it worked just fine.

Not sure what the spec is for the feeler gauge. Haynes might have it.
 
Ditto on what hawk said, I've heard and match book is about the .018 thickness. Keeps one in his 40 if ever needed on the trail.
 
Back
Top Bottom