FZJ80 Driver side (left) kick panel wiring pics?

[Rusty Cruiser]

Does anyone have a picture of an unmolested drivers side kick panel wiring? Mine is a 1995 and is a rats nest and I’m trying to get a clue on how it all lays in there as it should. The section laying in the floor was an intermediate piece going from the ignition connector to the main harness and I’ve confirmed everything seems to work with it out but it is still tied in with stuff in the kick panel. Best I can tell it was some kind of alarm wiring. Trying to decide if I should start un taping what goes down into the kick panel wiring and remove it completely or just zip tie it up out of the way under the dash.

 

[Rusty Cruiser]

Well I got it figured out. All the extra wiring was a security system that had harness sections that fit in between the ignition switch and main harness as well as two other sections down in the kick panel and then the control box under the carpet right in front of the drivers seat. Got it all removed and the factory plugs back together. It fits much better after. After driving about week, this seems to have been the source of my no crank issue.

 

[Rusty Cruiser]

Looks like at some point someone tied into the intermediate harness in several places for something else that was later removed but the wires just left bare.

 

[Malleus]

Those alarms are a perennial source of problems.