Just did a complete cooling system flush and restored the system back to Toyota red coolant. I also replaced all of the cooling system hoses. After I did the flush the front heater doesn't seem to be blowing hot like it seems it should. I've only had the truck for about a month and I don't think I ever checked the operation of the front heater to have something to compare it to...but it just seems weak.
First off...are the heater cores made out of aluminium? I spoke with a guy at the hardware store who showed me a chemical in the kitchen section that he used to unclog his...the instructions on the container said that it wasn't recommended for aluminum though. I forgot what the name of the product is.
I'm not familiar enough with how the coolant flows through the heater cores to be able to isolate just the front heater core so I can flush it without having to drain the whole system again if that's even possible.
Can someone offer some insight on this?
First off...are the heater cores made out of aluminium? I spoke with a guy at the hardware store who showed me a chemical in the kitchen section that he used to unclog his...the instructions on the container said that it wasn't recommended for aluminum though. I forgot what the name of the product is.
I'm not familiar enough with how the coolant flows through the heater cores to be able to isolate just the front heater core so I can flush it without having to drain the whole system again if that's even possible.
Can someone offer some insight on this?