Front Diff Gear Oil

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 24, 2007
Threads
16
Messages
235
Location
Colorado
Hey all...I just finished servicing the front axle of my 80. Repacked/replaced bearings, knuckles, etc. I put 80-90W oil in the front diff until it started to come out of the fill plug. It took about 3.5 qts. I was going through the FAQ which calls for 2.8 qts for an axle with lockers. I was careful putting the axles back in so I don't think I destroyed an inner seal which would cause it to leak diff oil into the knuckle right away.
Has anyone run into any problems filling it to over 2.8 qts and should I drain some of that back out?
 
I remember I was puzzling about the same thing. (Did not really count how much, but it was definitely above 3 qt). This was a couple of months ago, I did not notice any problem - assuming the gear oil would leak out from knuckle by now. I think you'll be alright.
 
Thanks for the replies...I feel a little better now. Was starting to think all that was going into the knuckle.....AAAARRRGGHHH!
 
Back
Top Bottom