Front Bumper

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Atticus, I'm glad i read this..:beer:. i've got a gray OEM bumper that a fella was looking to buy off me that has a '92. He said he just needs the right-end piece, but was planning on buying the whole thing. I'd hate for him to buy something that won't fit. :crybaby:

Does anyone know if the side pieces are the same fit to different bracket versions of the center-piece? If i'm following this correctly... either '91-'94 use one bracket configuration and the '95-'97 version is different. OR... are there 3 versions of the bracket configs: '91-'92; '93-'94; & '95-'97? :confused:

Either way... the question remains... are the side pieces of the bumper interchangeable with any of the '91-'97 front bumper center-piece? :bang:

Also... any idea what an OEM bumper would run? Used, no damage... just a take-off for an ARB re-fit. :meh:

Thanks.

Sean

If it's a complete setup, I say it will work.

I changed my mind regarding a heavy-duty front bumper and went with the front bumper from a '97 LX for my '91 FJ80; mainly because I just happened to come across it on craigslist and it was for sale at a good price.

It also helps that the factory bumper is relatively light weight since I'm on a quest to break 19 mpg (almost there - and then 20 mpg after that). But, I digress.

So, '97 front bumper fits '91 (and so, '92).
The '97 LX bumper came complete; had both corners and the later-style corner brackets.
Right away, I could tell the difference in the bumpers from the photos I received from the seller. All I knew is, same family, should fit. And it does. (I painted the bumper black; what looks like a gap on the corner section on the right is actually a reflection from the sunlight.)

I didn't have to use the funky corner bracket set-up from the '91, but the '97 setup is simple enough; complete, it's a fairly straight-forward direct bolt-on.

Maybe it's just my truck, but I did find the upper bolt holes on the '97 center brackets were off a bit from the top holes on each rail of the '91 frame; I filed the corresponding hole on each center bracket just enough to match up with the top holes on the frame.

Oh, another note: The stock '91/'92 bumper is 4" deep and the LX bumper is 5-1/2" deep.

It works.
Now, I just need to replace or massage the front lower valance.
Regards,
DSCN3933b.webp
 
Voor,

Thanks for the detailed response with your experience on this issue. Now I can feel confident to give the prospective buyer a call and tell him to come on by.

Cheers! I owe you one. :beer:

Sean
 
checking on the status of the bumper sale...if its still for sale I will take it.

mike
 
Back
Top Bottom