Front axle question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 16, 2007
Threads
2
Messages
6
About six months ago, I rebuilt my front axle because the LF wheel was throwing grease all over my Cruiser. I went ahead and rebuilt both sides because the truck had 146k and I thought it was probably time.

My problem is that I have only put about 4k on the truck since then and my LF knuckle looks greasy again.

Have I knicked the inner axle seal re-assembling everying? Or is there something else going on? The RF knuckle looks great, so needless to say I am confused.

Any help you guys could give me would be great.

Thanks!
DSCF1755-2.webp
 
Are you sure you got the knuckle gasket order correct? Metal piece fits in knuckle recess, then the rubber seal with ridge facing diff, then the felt, then the metal 2 piece ring. With that kind of mileage logged though, it seems like it would have leaked sooner if this was wrong. :confused:. Did you potentially overfill the cavity?

At this point, you will probably want to tear it down to the point where you can tell if its grease blowing past the knuckle seal, or gear lube blowing by the axle seal. Get it down to those bolts holding the backing plate assembly on and see what you see from there.
 
Back
Top Bottom