Front Axle Problem, Help!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 29, 2006
Threads
6
Messages
13
Hello- I have been working on the front "axle job" for a while now- don't ask how long. It sure is good to have an extra car to take to work and an understanding wife.

I can't seem to get the ds front axle shaft to go in all the way- it sticks out an extra inch or two. The passenger short axle went in no problem. I have the flat edge of the birfield facing up like I did with the ps but I can't get it to go all the way.

Does anyone have any ideas of what I might try?

BTW, I have a 1997 LC, non locking.

Thanks and TGIF!:beer::beer::beer:

Ken
 
Is it hitting the ABS sensor?
 
Before the axle slides in the carrier, your supposed to push down a little on the birfield, this lifts the axle end up so it can slide in. Also the suggestion above sounds like a possibility, you might want the ABS sensor out so its not in the way, but i really don't know because I don't have ABS, AB's, or a FSM. Also and probably most important, DO YOU HAVE LOCKERS? If so you were supposed to lock them before removing the axle, otherwise I hear its a pain but can be down. You might have to search on how to do that though. Good luck, and would you wrap it up allready, I can see the light from here.
 
Beside the problems explained in the 2 previous posts have someone turn the other axle while you try to seat the axle into the 3rd I had the same trouble with front and rear axle rebuilds. It just has to be lined up.
 
Before the axle slides in the carrier, your supposed to push down a little on the birfield, this lifts the axle end up so it can slide in...

x2. That's the key!
 
Got itl Thanks.

Thanks. Tenzig, you suggestion seemed to make it work. I did turn the ps axle a bit as JerseyCruiser suggested- maybe that helped some too. I had the ABS sensor out already. Well I'm happy for now until I break/lose another part- oil seal, dust seal bolt, knuckle gasket so far. Each adds about 4 days ea. to source the part. I know, excuses, excuses.

Thanks again,

Ken
 
Well don't feel sorry. Even for experienced tech, front birf job on fzj is very time consuming and extremely messy!
And longer axle is always pain to put back. gently hold down the CV end to lift other end while sliding in. you'll get it.
also make sure steering is straight; or, birf won't go into it's housing.
It's probably better to get the whole seal kit from the get go.
I did try to save a few bucks, but I ended up spending more by getting piece by piece.
Good luck.
 
Last edited:
Back
Top Bottom