front 3rd swap, 75 to ??

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 16, 2005
Threads
13
Messages
1,023
so I got a disc front , complete assembly, diff, axles, brakes, etc. (known good)

first, can I just call this a 3rd member?? (don't know if I have the right tech term)

second, I don't have a clue what year it is off, how can I tell if it's compatible?

third, it is missing one axle shaft.

right now I have a 75 40 with drums on all 4 wheels,

so,
how can I tell whether or not this has the same gearing as mine.
I think it is off a 76, but really not sure.
will the axle shaft off my drum brake 75 40 fit into this assembly

do I need to do any brake valve stuff, or is it as simple as pulling out the little washer thing in the M/C side of the brake line as seen in tech links?

I don't really know much about this stuff, if anyone can set me on the right track, I would appreciate it very much
when I searched everything I came up with was minitruck conversions, no simple landcruiser to landcruiser stuff. or is that just 'cause it's so easy and straighforward?

thanks:beer:
 
Last edited:
note:
I am probably :banana: :banana: in summer, but I have no shop and it's hovering around 0 farenheit, -17 or so celsius, so this is either
A future project I'm researching, or
B crappy weekend if it's going to be easy (ish)
but my current drum front has two frozen adjusters and leaky axle seals, so no point throwing money at it if it would be just as easy to replace it with a disc one
incidentally, does anyone need a set of front drum brake cylinders, bought them before I got a smokin' deal on the complete disc assembly, but maybe some purist doing resto stuff...
 
The shaft will prob fit. The gearing should be the same IF it is a pre Feb of 79 axle.

You do have the disk axle birfields, right?

I put a 4-79 axle into my 71, and had to swap the pumpkin. I did change to a disk brake master cyl, but you shouldn't have to.
 
thanks, yes, I've got the whole works, warn hubs, and everything in between them,
even good brake shoes and rotors.

any input on the brake valving, does that only need to be fooled with if you're doing rear discs?

so all I'd need to do is

lift truck
unbolt steering bits
unbolt spring shackles
unbolt u-bolts
disconnect brake hoses
out with the old, in with the new, button it all back up
lower truck
done

does this sum it up? sounds too easy.

thanks
 
Back
Top Bottom