Four Wheel Drive

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 7, 2005
Threads
3
Messages
15
I have a 1968 fj cruiser and the fwd won't engage when i pull the lever. i have checked all the linkage and replaced the transfer case and still the darn thing won't engage all the time, and when it does(very rarely) then it won't disengage without messing with it for hours on end. i don't know what to do next. anyone with any ideas please let me know. Thanks :confused:
 
Did you replace the transfer case because of this or another reason?

Have you had someone try it while looking at it from the bottom to see if the linkage is binding somewhere. You could take the linkages and levers off and try to move the shafts by hand to see if the binding is inside the case.
 
Doesn't a '68 have a vacuum-actuated transfer case? If so maybe it's a problem there...
 
yup. unless PO had changed to a later model t case. check for a vacuum leak it could be your problem good luck :beer:
 
If it has problems both engaging and disengaging (and assuming it's still got a vacuum setup), the problem is most likely in the vacuum line to the switching vavle on the firewall, or the valve itself. The diaphragms go bad - I think there's a factory rebuild kit though if that's the only problem.
 
Back
Top Bottom