Floor mat/carpet clip identification

[Eurasiaoverland]

I'vee been cleaning up my floor mats and notice on the parts diagram (see highlighted below) that there should be two small clips. Running the part number, these clips are NLA in any colour. I don't really see an obvious place where a clip would go, either on the carpet or the floor pan/sills. I don't believe it refers to the plastic channels which are stapled to the edges of the mat.

Can anyone share a picture or at least a description of what these clips are?

Thanks

EIO

 

[jjvbva]

This was the area on my FJ62. Clip for the electrical run?

 

[Eurasiaoverland]

Hey, thanks. It's going to be a clip associated with the carpet/mat though I think.

 

[jjvbva]

Velcro tabs is what I see here. No clips.

 

[Eurasiaoverland]

Velcro tabs is what I see here. No clips.

View attachment 4087970

View attachment 4087972

Thanks, I have the same. I wonder if it's a spurious part on the diagram.

There are meant to be two of these clips, and they are colour-specific (grey or brown on a 60 Series). They look to be located close to the raised bracket where the front of the seat rails bolt down, but my floor mat has only got the holes for the seat bolts.

 

[sved]

This is what you are looking for. Left and right besides the centerconsole

 

[Eurasiaoverland]

This is what you are looking for. Left and right besides the centerconsole
View attachment 4088496View attachment 4088497View attachment 4088498

Ah thank you, that must be it!

I have a front bench seat with no centre console so I don't think I have anything to clip these into. Appreciate the photos, thanks.

 

[sved]

Ah thank you, that must be it!

I have a front bench seat with no centre console so I don't think I have anything to clip these into. Appreciate the photos, thanks.

Bench seats have different attachment points then captain seats,but i think they use the same carpet layout. I not sure but my HJ60 and 61 have some unused holes/attachment points in the floor structure for bench seats. So i quess there should be some unused holes in your floor structure which could have this clips mounted.

 

[Eurasiaoverland]

Bench seats have different attachment points then captain seats,but i think they use the same carpet layout. I not sure but my HJ60 and 61 have some unused holes/attachment points in the floor structure for bench seats. So i quess there should be some unused holes in your floor structure which could have this clips mounted.

Are they clipping into the unused bolt holes on the bracket which runs across the floor pan and takes the front mounts of the seats? On a 60 with separate seats, I would expect both sides to use the triangular brackets for the inner seat rails. Mine only uses this point on the driver's seat, but in your picture it looks like the clip is further to the centre. My floor mat (moulded plastic, not carpet) definitely dos not have holes here.

 

[sved]

Solved the mystery.
I confused myself due to the fact that I installed swing seats in my HJ60.
They have the boltholes more inward on the frontside.