Yep, another lined flare thread. In addition to the flares, I did the backs of the mirrors, rear ‘bumperettes’, and the side ‘trim’ areas. I’ve used Hurculiner in the past for the tub of my 40 and the cargo area of the Suburban. After reading 95eighty’s thread Bed Liner in Place of Factory Flares... and seeing his results using the spray-on liner U-POL, I went with that. U-POL is a two part product that seems super durable. It sprayed on very easily and clean up was quick and simple. As always, the hardest part
is the prep; sanding/degreasing.
U-POL
First thing was to remove the flares, mirror backs and bumperettes.
Front flares have four 10mm nuts inside the fender. I accessed the front two by removing the turn signal and the back two through the rear engine bay ‘port’. There are also two 10mm bolts one the outside at the front and rear, and one clip near the door.
Inside fender:
Engine port:
Rear doors have two 10mm bolts (top and bottom) and two clips. The rear quarter panels have two 10mm nuts, two clips, and one outside. You have to remove the mud flap and drop the front of the bumperette to get to the last bolt. The mud flap has six 10mm bolts and the bumperette (to completely remove it) has one 10mm bolt (inside the wheel well) two 12mm bolts and three 8mm bolts. (Mirror dismantle consisted of 6 screws. Two outside, four inside)
Inside rear QP:
Flareless:
Prepped bits. I sanded using a palm sander the hand sanded parts the palm sander couldn’t get. Taped off the areas I didn’t want liner on and wiped everything clean with xylene.
Masked for trim. This is just the outline of the area I wanted to cover. I had the whole truck covered in plastic for the spray.
Freshly sprayed parts and trim.
is the prep; sanding/degreasing.
U-POL
First thing was to remove the flares, mirror backs and bumperettes.
Front flares have four 10mm nuts inside the fender. I accessed the front two by removing the turn signal and the back two through the rear engine bay ‘port’. There are also two 10mm bolts one the outside at the front and rear, and one clip near the door.
Inside fender:
Engine port:
Rear doors have two 10mm bolts (top and bottom) and two clips. The rear quarter panels have two 10mm nuts, two clips, and one outside. You have to remove the mud flap and drop the front of the bumperette to get to the last bolt. The mud flap has six 10mm bolts and the bumperette (to completely remove it) has one 10mm bolt (inside the wheel well) two 12mm bolts and three 8mm bolts. (Mirror dismantle consisted of 6 screws. Two outside, four inside)
Inside rear QP:
Flareless:
Prepped bits. I sanded using a palm sander the hand sanded parts the palm sander couldn’t get. Taped off the areas I didn’t want liner on and wiped everything clean with xylene.
Masked for trim. This is just the outline of the area I wanted to cover. I had the whole truck covered in plastic for the spray.
Freshly sprayed parts and trim.

